TuYa TS130F

   
Model TS130F
Vendor TuYa
Description Curtain/blind switch
Exposes cover (state, position), moving, calibration, motor_reversal, backlight_mode, calibration_time, linkquality
Picture TuYa TS130F
White-label LoraTap SC400

Notes

Pairing

Press on stop button for 10 seconds to enter pairing mode

Calibration

  • Press the open button on the switch, wait until the curtains are completely open.
  • Press the pause button on the switch.
  • Put the device into calibration mode, see below.
  • Press the close button on the switch, wait until curtains are fully closed.
  • Press the pause button on the switch.
  • Disable the calibration mode, see below.

Options

How to use device type specific configuration

  • invert_cover: Inverts the cover position, false: open=100,close=0, true: open=0,close=100 (default false). The value must be true or false

Exposes

Cover

The current state of this cover is in the published state under the state property (value is OPEN or CLOSE). To control this cover publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"state": "OPEN"}, {"state": "CLOSE"}, {"state": "STOP"}. It’s not possible to read (/get) this value. To change the position publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"position": VALUE} where VALUE is a number between 0 and 100.

Moving (enum)

Value can be found in the published state on the moving property. It’s not possible to read (/get) or write (/set) this value. The possible values are: UP, STOP, DOWN.

Calibration (binary)

Value can be found in the published state on the calibration property. To read (/get) the value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get with payload {"calibration": ""}. To write (/set) a value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"calibration": NEW_VALUE}. If value equals ON calibration is ON, if OFF OFF.

Motor_reversal (binary)

Value can be found in the published state on the motor_reversal property. To read (/get) the value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get with payload {"motor_reversal": ""}. To write (/set) a value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"motor_reversal": NEW_VALUE}. If value equals ON motor_reversal is ON, if OFF OFF.

Backlight_mode (enum)

Value can be found in the published state on the backlight_mode property. To read (/get) the value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get with payload {"backlight_mode": ""}. To write (/set) a value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"backlight_mode": NEW_VALUE}. The possible values are: low, medium, high.

Calibration_time (numeric)

Calibration time. Value can be found in the published state on the calibration_time property. It’s not possible to read (/get) or write (/set) this value. The unit of this value is S.

Linkquality (numeric)

Link quality (signal strength). Value can be found in the published state on the linkquality property. It’s not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 255. The unit of this value is lqi.