Lutron LZL4BWHL01

   
Model LZL4BWHL01
Vendor Lutron
Description Connected bulb remote control
Exposes action, linkquality
Picture Lutron LZL4BWHL01

Notes

Pairing

Factory reset the Lutron Connected Bulb Remote by pressing and holding the remote’s top and bottom buttons for approximately 15 seconds. The light on the remote will blink rapidly to indicate that the remote has been reset.

After resetting the remote can be paired to a network by pressing and holding the top button for approximately 2 seconds.

Connected light bulbs can be reset with the Lutron Connected Bulb Remote by bringing the remote close (~3 inches) to the light bulb and pressing and holding the remote’s 2nd and bottom buttons. The light bulb will flash and the remote’s LED will turn on. Continue to hold both buttons until the remote’s LED turns off.

After resetting the bulb will automatically attempt to join a network.

This method should work for Philips Hue bulbs, IKEA TRADFRI bulbs, GE Link bulbs, Connected Cree bulbs, and EcoSmart SMART bulbs.

Options

How to use device type specific configuration

  • legacy: Set to false to disable the legacy integration (highly recommended), will change structure of the published payload (default true). The value must be true or false

Exposes

Action (enum)

Triggered action (e.g. a button click). Value can be found in the published state on the action property. It’s not possible to read (/get) or write (/set) this value. The possible values are: brightness_step_down, brightness_step_up, brightness_stop, brightness_move_to_level.

Linkquality (numeric)

Link quality (signal strength). Value can be found in the published state on the linkquality property. It’s not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 255. The unit of this value is lqi.