KMPCIL KMPCIL-tag-001

   
Model KMPCIL-tag-001
Vendor KMPCIL
Description Arrival sensor
Exposes battery, presence, power_state, occupancy, vibration, temperature, linkquality
Picture KMPCIL KMPCIL-tag-001

Notes

Installation

The Arrival Sensor will be in pairing mode when it is first powered up. You can force it to go back into pairing mode by factory resetting the sensor in the following steps.

1.remove all power (battery and dc) 2.press the button on the back of the board. 3.plug the dc power and count to 4 to 5 seconds (not more). 4.release the button. At this point, the module is in pairing mode.

Once the Arrival Sensor is in pairing mode, please follow the standard Zigbee2Mqtt pairing process for a new device.

Additional notes

Please visit https://community.home-assistant.io/t/zigbee-arrival-sensor-for-car/382529/7

Options

How to use device type specific configuration

  • presence_timeout_dc: Time in seconds after which presence is cleared after detecting it (default 60 seconds) while in DC. The value must be a number with a minimum value of 60

  • presence_timeout_battery: Time in seconds after which presence is cleared after detecting it (default 420 seconds) while in Battery. The value must be a number with a minimum value of 120

  • temperature_precision: Number of digits after decimal point for temperature, takes into effect on next report of device. The value must be a number with a minimum value of 0 and with a with a maximum value of 3

  • temperature_calibration: Calibrates the temperature value (absolute offset), takes into effect on next report of device. The value must be a number.

Exposes

Battery (numeric)

Remaining battery in %, can take up to 24 hours before reported.. Value can be found in the published state on the battery property. It’s not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 100. The unit of this value is %.

Presence (binary)

Indicates whether the device detected presence. Value can be found in the published state on the presence property. It’s not possible to read (/get) or write (/set) this value. If value equals true presence is ON, if false OFF.

Power_state (binary)

Value can be found in the published state on the power_state property. It’s not possible to read (/get) or write (/set) this value. If value equals true power_state is ON, if false OFF.

Occupancy (binary)

Indicates whether the device detected occupancy. Value can be found in the published state on the occupancy property. It’s not possible to read (/get) or write (/set) this value. If value equals true occupancy is ON, if false OFF.

Vibration (binary)

Indicates whether the device detected vibration. Value can be found in the published state on the vibration property. It’s not possible to read (/get) or write (/set) this value. If value equals true vibration is ON, if false OFF.

Temperature (numeric)

Measured temperature value. Value can be found in the published state on the temperature property. It’s not possible to read (/get) or write (/set) this value. The unit of this value is °C.

Linkquality (numeric)

Link quality (signal strength). Value can be found in the published state on the linkquality property. It’s not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 255. The unit of this value is lqi.